How to Apply and Remove Wyze Cam v4 Skins by dBrand

Quick answer

Apply your Wyze Cam v4 skin by aligning the cutouts, pressing from the center outward, and using a hairdryer for stubborn edges. To remove, heat the skin gently and peel slowly to avoid residue.

Step-by-step skin application and removal

1. Clean the camera surface: Wipe the Wyze Cam v4 with a microfiber cloth and isopropyl alcohol to remove dust and oils. Let it dry completely. Even a tiny speck of dust causes a visible bump under the skin.
2. Align the skin before sticking: Peel a small corner of the backing, hold the skin over the camera, and align the lens and sensor cutouts. Press only the aligned section down. Once the adhesive touches the plastic, repositioning is nearly impossible without stretching.
3. Press from center outward: Work the skin flat using your thumb or a soft card, pushing air bubbles toward the edges. Move slowly and firmly. If a bubble remains, lift the nearest edge slightly and re-press; never poke the vinyl.
4. Heat and seal the edges: Use a hairdryer on low heat to warm the edges, then press them down with a cloth. This activates the adhesive for a permanent bond. Overheating can warp the vinyl — keep the dryer moving and at least 6 inches away.
5. Remove by heating first: When you want to remove the skin, warm it with a hairdryer for 30–60 seconds until the vinyl feels soft. Peel from one corner at a 45-degree angle. If the skin resists, apply more heat. Pulling cold vinyl leaves adhesive residue on the camera.

What you are working with

• Wyze Cam v4 Skins by dBrand (Skin Only): Some Wyze Cams are comfortable in their own skin. Some aren't, and that's okay. If your Wyze Cam is uncomfortable in its own skin, don't waste your money on therapy or self-help books. Just buy it new skin. Fancy new skin from dBrand. Your Wyze Cam v4 will thank you. The dBrand skin is a precision-cut vinyl wrap that changes the look of your camera without adding bulk or blocking sensors.